- #Apple airport base station m8440 manual mac os x
- #Apple airport base station m8440 manual pdf
- #Apple airport base station m8440 manual Pc
FCC regulations limit ISP transmission speeds to 53 Kbps in the United States. Download speeds vary with line conditions and your ISP's modem capabilities.Initial AirPort setup requires an AirPort-enabled Macintosh computer.
Bandwidth access is dependent on the number of simultaneous users.
#Apple airport base station m8440 manual Pc
A PC with a Wi-Fi-certified IEEE 802.11b wireless card.At least one AirPort-enabled Apple computer (to set up the base station).
#Apple airport base station m8440 manual mac os x
Mac OS 9.0.4 or later or Mac OS X 10.1 or later. An Apple computer with an antenna and AirPort Card. Mass (weight, without wall mount bracket): 1.25 pounds (565 grams). Maximum storage altitude: 15 000 feet (4572 m). Operating altitude: 0 to 10 000 feet (0 to 3048 m). Relative humidity, storage: 10 to 90 percent, noncondensing. Relative humidity, operational: 20 to 80 percent. Storage temperature: -13 F to 140 F (-25 C to 60 C). Operating temperature: 32 F to 95 F (0 C to 35 C). #Apple airport base station m8440 manual pdf
Designing AirPort Networks 2 PDF document. AirPort Admin Utility - base station network administration (for Mac OS 9 and X). AirPort Setup Assistant - set up the computer for network access and set up an AirPort Base Station (for Mac OS 9 and X). AirPort Control Strip module - quickly measure signal strength or change networks (for Mac OS 9). AirPort application - change networks and check signal strength (for Mac OS 9). The Ethernet jacks will not allow a telephone wire's clip to insert far enough to lock into place. This has been done to prevent confusion from misplugged wiring. Both the WAN and LAN Ethernet ports automatically detect the type of connection and switch the signal configuration as required.The Ethernet jacks do not accept telephone wire (RJ-11). Note: When connecting the AirPort Base Station (Dual Ethernet) to to another device using Ethernet, a crossover cable is not required. RJ-45 connector for built-in 10/100BASE-T Ethernet for connecting to wired computers (LAN, "local area network"). RJ-45 connector for built-in 10BASE-T Ethernet for connecting a DSL or cable modem (WAN, "wide area network"). RJ-11 connector for built-in 56K V.90 modem for dialup Internet connections (See Note 3.). AirPort menu bar item to measure signal quality, change networks, and turn AirPort on and off. 
AirPort application to monitor connection status, turn AirPort on and off, change networks, and check signal quality. Internet Connect application for dialing support and to monitor connection status, turn AirPort on and off, change networks, and check signal quality (Mac OS X 10.1 only). AirPort Admin Utility for base station network administration. AirPort Setup Assistant to configure the computer and AirPort Base Station for Internet access. Works with Windows-based PCs and Mac computers (See Note 2). Up to 168-foot (50 m) radius from the base station in typical use. Up to 11 Mbps (data rate depends on environment). It includes a base unit, external power supply, telephone cord, wall mount bracket, and software. The AirPort Base Station (Dual Ethernet) can serve up to 50 users (See Note 1). AirPort Base Station (Dual Ethernet) - Technical Specifications Technical Specifications
0 kommentar(er)
